Especially recommended for:

• Wide circlip profiles​
• Radius form grooves up to R = 3 mm
• Face grooving applications from DMIN 20
• Special profiles up to 6,5 mm

Especially recommended for:

• Wide circlip profiles​
• Special profiles up to 8mm for e.g. internal grooving, V-rip profiles or tailor made grooves

Particularly suitable for:

• Tight and narrow cutting areas (e.g. near to the working spindle)
• Finishing and profile turning with low cutting depths
• Face turning/thread clearance
• Difficult materials such as titanium or aluminum alloys
• Components with high surface quality

Application & advantages DECO

• Back turning operations in tight areas
• Roughing and finishing
• Average cutting depths (ap = 1-2 mm)
• Perfect chipping
• Steel and alloyed steel

Grooving and turning insert from our P92 P system, for profiling and copying.
It has been developed, to machine materials, which are difficult to cut, like:

• nonferrous heavy metals
• nickel alloys
• plastic materials
• composite materials
• aluminum alloys

Polished surfaces, sharp cutting edges

Grooving and turning insert from our P92 P system, for grooving and copying.
In these applications the STV is unbeatable:

• Radial profiling behind the collar
• Radial relief groove behind the collar
• Axial profiling
• Internal machining

Specially developed for machining difficult-to-machine materials such as:

• nonferrous heavy metals
• nickel alloys
• plastic alloys
• composite materials
• aluminium alloys

polished surface and sharp cutting edges

Roughing: Geometry with zero degree chamfer x 0,2 mm.
Medium machining: Wiper Geometrie scharf schneidend und gekennzeichnet durch eine stabile Nullgradfase x 0,1 mm.
Finishing: Sharp cutting geometry, polished.

LTNN Grooving geometry for parting off long chipping materials.
Especially recommended for double-spindle lathes.Stechgeometrie zum Abstechen langspanender Materialien.

• High feeds
• Easy cutting geometry
• Reinforced flanks
• Short chipbreaker

High positive parting off geometry
Ground top rake with 0,1 mm chamfer on the major cutting edge for stabilisation.
Especially recommended for: NE materials and difficult to cut materials
Application: profiling

Chip breaker: Especially developed for effective chip flow when face grooving.
Insert: Developed for machining of stainless and alloyed steels.
Clearance: Especially for face grooving.
Remark: To be used as well for radial grooving and parting off.

Type with one cutting edge. Deep cutting depth and clean turning faces. Reduce feed while cutting depth increases.Grooved parting off edge with reinforced flanks. The deep and spacios chip-through gives excellent chip control. Efficent on almost all materials.

The P92 A CTD is a grooving insert specifically for parting off. The chamfered main cutting edge with reinforced flanks with a spacious chip space are suitable for machining alloyed and stainless steels as well as components with an interrupted cut.

GTNS grooving insert, tapered version with 1 cutting edge.
P92 A plates and P92 A CXCB ... holders combine to form a technically rigid unit due to the long plate seat guide. This tool connection is therefore particularly suitable for large grooving depths and deep recesses.

The P92 A SCTD is a grooving insert specifically for parting off. The honed main cutting edge with a spacious chip space and the reinforced flanks are suitable for machining alloyed and stainless steel.