KEMMER SALES AND SERVICE: +49 7054 / 92 91 - 0

ETNZ

ETNZ

Inserts for grooving, turning and parting off
Roughing: The minor cutting edges and the radius area are marked through a zero degree chamfer x 0,2 mm. Crater wear will be reduced significantly.
Roughing and finishing: The minor cutting edges and the WIPER edge are sharp and are marked by a stable zero degree chamfer x 0,1 mm. The polished geometry reduce heat development and crater wear.
Finishing: The minor cutting edges and the radius area are sharp. The polished geometry reduce heat development, crater wear and built-up edges.